Get estimate

Site map.

Every page on the site, grouped by what it is for.

Available 24 hours

Licensed C-10 · CSLB #1115460

Emergency electrical

Residential services

Commercial

Service areas

Guides

  • All guides
  • Guides, page 2
  • Guides, page 3
  • Guides, page 4
  • Guides, page 5
  • 100A vs 200A serviceA 200-amp service is not automatically better, and 100 amps is not automatically too small. The right size is a load calculation, not square footage.
  • Breaker keeps trippingA tripped breaker tells you something changed on the circuit. Note what happened, reduce the connected load, and do not rely on repeated resets.
  • ADU electricalAn ADU adds a dwelling’s worth of load. The right design is a load calculation — not an automatic 200-amp service or a second meter.
  • AFCI vs GFCIAFCI vs GFCI explained — shock vs fire protection, where each is required in Sacramento, when you need both, breaker options, older homes and remodel rules.
  • Aluminum wiringHow to identify solid aluminum branch wiring in a 1965–1973 house, why the risk sits at the connections rather than the wire, why it is not the same as the aluminum at the meter, and the CPSC-recognized repairs — so a full rewire is not the only answer.
  • Bathroom remodel electricalPlan GFCI, lighting, the exhaust fan, heated floors, and specialty loads before tile and vanities close the walls. Call (279) 972-9272.
  • Breaker won’t resetA breaker that will not stay on is protecting the circuit or has failed. One proper reset. If it trips again, stop. Call (279) 972-9272.
  • Burning smell at an outletA burning or fishy smell at an outlet, switch, or breaker panel is overheating until proven otherwise. Stop using it. Isolate if you can. Then have the source found.
  • Can my panel take a chargerA Level 2 charger does not automatically mean a new panel or 200 amps. How much charging you need, and what the service can carry, decides it.
  • Christmas light installationHoliday lights are an electrical job before they are a decorating one. GFCI, outdoor circuits, and a timer — then the roofline. Call (279) 972-9272.
  • Fan-rated box for a ceiling fanA light box is not automatically a fan box. Listed fan support, weight rating, and structure — before the fan goes up. Call (279) 972-9272.
  • Electric tankless water heaterElectric tankless water heater requirements in Sacramento: amps, breaker size, wire size, 240V circuits, panel capacity, service size and permits.
  • Inspection before buying an older housePanel, service, grounding, two-prong outlets, aluminum or cloth wiring, GFCI, DIY work, and permit history — before you close. Call (279) 972-9272.
  • Electrical before a remodelRoom use, lighting, devices, major loads, access, and finish boundaries are easier to coordinate before construction decisions become fixed.
  • EV-ready garage electricalEV charging is one garage load among others. Plan the circuit, panel capacity, a second EV, workshop loads, and a subpanel before the garage is finished.
  • Federal Pacific panelsHow to identify a Federal Pacific or FPE Stab-Lok panel, the failure-to-trip concern behind the safety reputation, why new breakers are not the fix, and how a Sacramento replacement and permit work.
  • Gas-to-electric dryerGas-to-electric dryer conversion in Sacramento: 240V/30A circuit, NEMA 14-30 outlet, breaker, wire, GFCI, panel capacity and permit requirements.
  • Generator vs battery backupThe electrical job is the transfer method — inlet, interlock, or a gateway — sized to what has to stay on. The generator or the battery is a different purchase. Call (279) 972-9272.
  • GFCI will not resetA GFCI that trips may be doing its job. The useful split is a real fault, a failed device, or a problem somewhere else on the circuit.
  • Heat-pump mini-split circuitMCA and MOCP come from the outdoor unit, not a generic 240-volt guess. Disconnect in sight of the equipment. Call (279) 972-9272.
  • Home addition electricalNew rooms mean new circuits, lighting, HVAC power, and often a subpanel — planned before framing and drywall. Not an ADU clone. Call (279) 972-9272.
  • Home office electricalA home office is more than extra outlets. Plan the workstation, circuits, lighting, networking, and HVAC before the walls and cabinetry close.
  • Podcast studio electricalA studio is a small technical room. Plan circuits, receptacle locations, lighting, HVAC power, and low-voltage pathways before acoustic walls close.
  • Home theater electricalPlan circuits, projector power, lighting zones, AV equipment, and cable pathways before drywall, cabinetry, and acoustic treatment close the room.
  • Hot tub electrical requirementsA hot tub is not a generic outdoor outlet. Voltage, GFCI, disconnect location, bonding, and panel capacity have to match the spa before it is delivered.
  • Induction range circuitThe circuit is sized to the range you are actually installing — kW, amps, four-wire, cord or hardwire. The old gas outlet is not that circuit. Call (279) 972-9272.
  • Kitchen remodel electricalKitchen remodel electrical requirements in Sacramento: circuits, outlets, GFCI/AFCI, island power, appliances, panel capacity, permits and rough-in planning.
  • Level 2 EV chargerStart with parking, charging needs, panel capacity, and the circuit route. The charger itself is only one part of the installation.
  • One room losing powerIf one room goes dark and the rest of the house is fine, the fault is usually on one branch circuit — a breaker, a hidden GFCI, or a loose connection. Call (279) 972-9272.
  • Outdoor kitchen electricalGFCI, weather-rated boxes, in-use covers, and a 240-volt run only if the grill nameplate wants one. Not a hot tub, and not a floodlight. Call (279) 972-9272.
  • Outdoor lightingPathways, entries, glare, GFCI, wet-location ratings, and controls — before you pick fixtures. Call (279) 972-9272.
  • Dead outlet, breaker not trippedOutlet not working but the breaker isn’t tripped? Check the GFCI, breaker reset, wall switch, upstream connections, open hot or neutral, and warning signs.
  • Outage: utility or home?A broad outage usually starts with the utility. A partial outage or a condition isolated to one property may need an electrician.
  • Plan recessed lightingLayout, spacing, insulation contact, and switching — before anyone cuts a grid of holes. Cans vs wafers is a later choice. Call (279) 972-9272.
  • Recessed vs canless lightsHousings vs wafers — ceiling depth, insulation contact, dimming, and whether the room is already finished. Call (279) 972-9272.
  • Indoor vs outdoor saunaStart with the heater, not the room. Indoor and outdoor saunas can share a load and still be different wiring projects once the circuit leaves the house.
  • Signs you need a rewireFrequent breaker trips, flickering lights, and two-prong outlets can point to electrical problems — but not every symptom means a full rewire. Patterns decide the scope.
  • Types of electrical inspectionsCity permit, SMUD, home, and insurance electrical inspections in Sacramento each check different things — and each “pass” proves something different.
  • Ungrounded outletsUngrounded outlets are common in older homes. Two-prong is not the same as a three-prong with no ground. GFCI can protect the location; it still does not create a ground.
  • Electrical permits in SacramentoIf you are changing the permanent electrical system in a Sacramento home, there is a good chance the work requires a permit. City and County are different authorities. Minor permit is still a permit.
  • When a panel needs replacingWhat matters is not how old the box looks. It is whether the equipment, condition, capacity, and repair path still fit the property.
  • Which appliances need a dedicated circuitA range, dryer, water heater, EV charger, spa, or HVAC unit is not a shared receptacle circuit. The nameplate and the listing decide. Call (279) 972-9272.
  • Which circuits belong on backupThe list is the design. Fridge, heat, a well or sump, medical equipment, enough light to live — not the EV, the range, or the whole house by default. Call (279) 972-9272.
  • Electrification order of workHeat pump, water heater, induction, dryer, EV — sequenced so the panel is not opened three times. Call (279) 972-9272.
  • Flickering lightsOne LED on a dimmer is a different problem from half the house brightening and dimming. Where it happens, and what else changes, tells you where to start.
  • Buzzing electrical panelA faint steady hum is not the same as a new, loud, crackling, or load-dependent buzz. The pattern — and whether there is heat or odor — decides how urgent it is.
  • LED flicker on a dimmerUsually the bulb, the driver, and the dimmer are not a listed match — not a failing panel. Call (279) 972-9272.
  • Workshop 240V toolsA welder, a compressor, and a dust collector are three nameplates — not one shop breaker, not a leftover 14-50, and not an EV charger. Call (279) 972-9272.
  • Zinsco panelsHow to identify a Zinsco or GTE-Sylvania panel, the breaker-to-bus failure mode behind the safety reputation, why new breakers are not the fix, and how a Sacramento replacement and permit work.
  • Zinsco panel insuranceWhy a Sacramento insurer flags a Zinsco panel, whether replacement is required by the carrier or by code, what the letter usually asks for, and how the documentation and home-sale path work.

Company

Get estimate

Tell us what is happening, or what you are planning. We read the details, tell you what else we need to know, and explain the next step before anything is scheduled.

  1. 01

    You send the problem or the plan, with the address if you have it.

  2. 02

    We reply with what it involves and what has to be seen in person.

  3. 03

    Nothing is scheduled, and nothing is priced, until the equipment has been looked at.

License
CSLB #1115460 · C-10 electrical